Deactivating DISTRONIC PLUS
WARNING
The DISTRONIC PLUS switches off and
releases the brakes when the vehicle
decelerates below the minimum speed of
20 mph (30 km/h) by operation of the system
unless the DISTRONIC PLUS detects a vehicle
directly ahead of you. At that time the driver
must apply the brakes in order to reduce
vehicle speed further or bring it to a stop.
There are several ways to deactivate
DISTRONIC PLUS:
– Briefly press the cruise control lever
forwards 1.
or
– Brake, unless the vehicle is stationary.
When you deactivate DISTRONIC PLUS, the DISTRONIC PLUS Off message is shown in the multifunction display for approximately five seconds.
The last speed stored remains stored until you switch off the engine.
DISTRONIC PLUS is not deactivated if you depress the accelerator pedal. If you accelerate to overtake, DISTRONIC PLUS adjusts the vehicle's speed to the last speed stored after you have finished overtaking.
DISTRONIC PLUS is automatically
deactivated if:
- you engage the electric parking brake or if
the vehicle is automatically secured with
the electric parking brake
- you are driving slower than
15 mph (25 km/h) and there is no vehicle
in front, or if the vehicle in front is no longer
detected
- ESP® intervenes or you deactivate ESP®.
- the transmission is in the P, R or N position.
- you switch off the radar sensor system.
- you pull the cruise control lever towards
you in order to pull away and the frontpassenger
door or one of the rear doors is
open.
- you activate DSR.
- the vehicle has skidded.
If DISTRONIC PLUS is deactivated, you will hear a warning tone. The DISTRONIC PLUS Off message is shown in the multifunction display for approximately five seconds.
You can select the distance display in the Assistance menu (Y page 232) of the onboard computer.
Distance display when DISTRONIC PLUS is
deactivated
1 Vehicle in front, if detected
2 Distance indicator, current distance to
the vehicle in front
3 Specified minimum distance to the
vehicle in front; adjustable
4 Own vehicle
– Select the Distance Display function using the on-board computer.
See also:
Roof carrier
Important safety notes
WARNING
Only use carriers when the crossbars have
been completely mounted. The left and right
roof rails are only stabilized by means of the
crossbars mounted.
...
Inserting the brackets into the loading
rail
– Insert bracket 1 into the center of loading
rail 4.
– Press release button 2 and push
bracket 1 into the desired position in
loading rail 4.
– Let go of release button 2.
– Press lockin ...
Vehicle
Display messages
Possible causes/consequences and
Solutions
You have attempted to start the engine with the transmission in
position R or D.
Shift the transmission ...