Breaking-in notes

The first 1000 miles (1500 km)

The more you look after the engine when it is new, the more satisfied you will be with its performance in the future.

Drive at varying vehicle speeds and engine speeds for the first 1000 miles (1500 km) for this reason.
Avoid overstraining the vehicle during this period, e.g. driving at full throttle.
Change gear in good time, at the latest when the tachometer needle is 2/3 of the way to the red area in the tachometer display.
Do not manually shift to a lower gear to brake the vehicle.
If possible, do not depress the accelerator pedal past the point of resistance (kickdown).
Only select shift ranges 3, 2 or 1 when driving slowly, e.g. in mountainous terrain.

After 1000 miles (1500 km), you can increase the engine speed gradually and bring the vehicle up to full speed.

running in if the engine or parts of the drive You should also observe these notes on running in if the engine or parts of the drive train on your vehicle have been replaced.

restrictions. Always observe the respective speed restrictions.

    See also:

    TWR (Tongue Weight Rating)
    The TWR specifies the maximum permissible weight that the ball coupling of the trailer tow hitch can support. ...

    Emergency Tensioning Devices, belt force limiters
    The front seat belts and the outer seat belts in the rear are equipped with ETDs and seat belt force limiters. The ETDs tighten the seat belts in an accident, pulling them close against the body. ...

    On-board diagnostic interface
    WARNING If you connect equipment to the on-board diagnostics interface, it can affect the operation of the vehicle systems. This can impair the operating safety of your vehicle while driving ...