Changing the settings of the locking system
You can change the setting of the locking system in such a way that only the driver's door and the fuel filler flap are unlocked. This is useful if you frequently travel on your own.
- To change the setting: press and hold down the
and
buttons simultaneously for approximately six seconds until the battery check lamp () flashes twice.
If the setting of the locking system is changed within the signal range of
the vehicle, pressing the
or
button locks or unlocks the vehicle.
The SmartKey now functions as follows:
- To unlock the driver's door: press the
button once.
- To unlock centrally: press the
button twice.
- To lock centrally: press the
button.
The KEYLESS-GO function is changed as follows:
- To unlock the driver's door: touch the inner surface of the door handle on the driver's door.
- To unlock centrally: touch the inner surface of the door handle on the frontpassenger door or the rear door.
- To lock centrally: touch the outer sensor surface on one of the door handles.
See also:
Load index
In addition to the load bearing index, the load
index may also be imprinted on the sidewall
of the tire. This specifies the load bearing
capacity more precisely. ...
Belt warning for the driver and frontpassenger
Regardless of whether the driver and front
passenger have fastened their seat belts
already, the seat belt warning lamp
lights up for 6 seconds after every engine
start. It then goes out if the d ...
Important safety notes
WARNING
When leaving the vehicle, always remove the
SmartKey from the ignition lock. Always take
the SmartKey with you and lock the vehicle.
Do not leave children unattended in the
vehicle, ...