Search & Send
Points to observe before use
To use Search & Send, your vehicle must
be equipped with mbrace and a navigation
system. You must also have an mbrace
service subscription.
"Search & Send" is a destination entry service. A destination which is determined by Google Maps® or Yahoo Local Maps® can be forwarded directly to your vehicle's navigation system using TELEAID.
Specifying and sending the destination address
Information about specific commands
such as address entry or sending an
address can be found on (either of) the
website(s). Each website works differently
and is subject to change.
Go to either http://www.maps.google.com or http://www.maps.yahoo.com and
enter a
destination address in the entry field.
Press the relevant button on the website to
send the destination address to the e-mail
address of your mbrace account.
When the "Send" dialog window appears:
In the relevant field, enter the e-mail address which you specified when activating your mbrace account.
Click on "Send".
Calling up destination addresses
Press the MB Info call button to load the
destination address to your vehicle's
navigation system.
A display message appears, asking whether navigation should be started.
Slide
and turn
the COMAND
controller to select Yes and confirm by
pressing
.
The system calculates the route and subsequently starts the route guidance with the address entered.
If you select No, the address can be stored
in the address book.
If you have sent more than one
destination address, you have to make an
info call to load each individual address.
Destination addresses are loaded in the
same order as the order in which they were
sent. If you own multiple Mercedes-Benz
vehicles with mbrace and activated mbrace
accounts:
Each destination address sent can be
accessed by every vehicle which is
connected with the relevant e-mail
address.
See also:
Brakes
Important safety notes
WARNING
On slippery road surfaces, never downshift in
order to obtain braking action. This could
result in drive wheel slip and reduced vehicle
control. Your ve ...
Opening and closing
Overhead control panel
To open
To open
To close
Turn the SmartKey to position 1 or 2 in the ignition lock.
Press or pull the switch
in the corresponding direction.
If you press ...
Useful information
This Operator's Manual describes all
models and all standard and optional
equipment of your vehicle available at the
time of publication of the Operator's
Manual. Country-specific differe ...