Multicontour seat
Information about the components and
operating principles of COMAND can be
found on.
The contour of the driver's seat and frontpassenger seat backrests can be individually adjusted to provide optimum support for your back. This is achieved by controlling the pressure in the air chambers in the multicontour seat.
The adjustments are made using the COMAND display.
When you adjust the multicontour seat,
you may hear the air being pumped in or
released.
You can adjust the following air cushions:
• seat side bolsters
• seat backrest side bolsters
• backrest curvature in the lumbar region
• backrest curvature in the upper back region
Make sure that the SmartKey is in position
2 in the ignition lock.
Press the
function button.
Selecting the seat
You must first select the seat for which you wish to make adjustments.
Press the
function button.
The main area is active.
To move to the lower menu bar: select
by sliding
the COMAND controller
and press
to confirm.
To select a seat: select by sliding
or
turning
the COMAND controller and
press
to confirm.
Exiting a menu
There are several ways of exiting the menu for the multicontour seat:
Press the
function button again.
or
Press any function button.
or
Select another main function from the
basic menu.
Display values
Two values are displayed on the setting scale
if you adjust the multicontour seat:
• red: this is the desired value which you
specify when making the setting.
• white: this is the current value. It is changed
gradually until it reaches the desired value.
Adjusting the seat side bolsters
This function allows you to adjust the air cushions in the seat side bolsters.
Select the seat.
Select Seat Sides by sliding
or
turning
the COMAND controller and
press
to confirm.
A scale appears.
Select Setting by sliding
or turning
the COMAND controller and press
to confirm.
Adjusting the seat backrest side bolsters
This function allows you to adjust the air cushions in the seat backrest side bolsters.
Select the seat.
Select Seatb. Sides by sliding
or
turning
the COMAND controller and
press
to confirm.
A scale appears.
Select Setting by sliding
or
turning
the COMAND controller and press
to confirm.
Adjusting the backrest curvature in the lumbar region
This function allows you to adjust the air cushions in the lumbar region of the backrest.
Select the seat.
Select Lumbar by sliding
or turning
the COMAND controller and press
to confirm.
A crosshair appears. You can make two settings:
• Vertical: to move the point of greatest lumbar support up or down • Horizontal: to adjust the amount of support
Select Setting by sliding
or turning
the COMAND controller and press
to confirm.
Adjusting the backrest curvature in the upper back region
This function allows you to adjust the air cushions in the upper back region of the backrest.
Select the seat.
Select Shoulders by sliding
or
turning
the COMAND controller and
press
to confirm.
A scale appears.
Select Setting by sliding
or turning
the COMAND controller and press
to confirm.
Resetting adjustments
You can reset the seat settings to the factory settings.
Select the seat.
Select Reset All by sliding
or
turning
the COMAND controller and
press
to confirm.
See also:
Important safety notes
WARNING
Severe conditions (e.g. strong air pollution) may require replacement of the
filter before its scheduled replacement interval. A clogged filter will reduce the
air volume to the inte ...
Tightening the cargo net
Seat belt reel holder behind the front seats
► Insert belt hook 1 into cargo tie-down
ring 2 in the direction of the arrow.
► Pull tensioning strap 3 by the loose end
in
the direct ...
System self-test
The indicator lamp illuminates
when you:
• turn the SmartKey to position 1 or 2 in the ignition lock
• on vehicles with KEYLESS-GO, press the Start/Stop button once or twice
If an adult occupant ...