Cleaning the paintwork
Scratches, corrosive deposits, areas affected by corrosion and damage caused by inadequate care cannot always be completely repaired. In such cases, visit a qualified specialist workshop, e.g. an authorized Mercedes-Benz Center.
•► Remove impurities immediately, where possible, whilst avoiding rubbing too hard.
•► Soak insect remains with insect remover and rinse off the treated areas afterwards.
•► Soak bird droppings with water and rinse off the treated areas afterwards.
•► Remove coolant, brake fluid, tree resin, oils, fuels and greases by rubbing gently with a cloth soaked in petroleum ether or lighter fluid.
•► Use tar remover to remove tar stains.
•► Use silicone remover to remove wax.
Do not affix:
- stickers
- films
- magnetic plates or similar items
to painted surfaces.
You could otherwise damage the paintwork.
If water no longer forms "beads" on the paint surface, use the paint care products recommended and approved by Mercedes- Benz. This is the case approximately every three to five months, depending on the climate conditions and the care product used.
If dirt has penetrated the paint surface or the paint has become dull, the paint cleaner recommended and approved by Mercedes- Benz should be used.
Do not use these care products in the sun or on the hood while the hood is hot.
•► Use a suitable touch-up stick, e.g. MB Touch-Up Stick, to correct smaller areas of paint damage quickly and provisionally.
See also:
Problems with fuel and the fuel tank
Problem
Possible causes/consequences and
Solutions
Fuel is leaking from the vehicle.
Risk of explosion or fireThe fuel line or the fuel tank is
defective.
Turn the ...
Extending/retracting the rear window
blind
Make sure that the rear window blind can
move freely. Otherwise, the blind or other
objects could be damaged.
The rear window blind is deactivated at
temperatures below -20 °C.
To extend/ ...
Mute
Switching audio and video sources on/off
Press the button on the
multifunction
steering wheel.
The sound from the respective audio or
video source is switched on or muted.
When the sound ...
