Resetting the panorama roof with power tilt/sliding panel and the roller sunblinds
Reset the panorama roof with power tilt/sliding panel and the roller sunblinds if the panorama roof with power tilt/sliding panel or the roller sunblinds do not move smoothly.
Turn the SmartKey to position
1 or 2 in the ignition lock.
Press the
switch to the point of
resistance in the direction of arrow 2 and
hold it until the panorama roof with power
tilt/sliding panel has opened about 4 in
(10 cm).
Pull the
switch repeatedly to the point
of resistance in the direction of arrow 3
until the panorama roof with power tilt/sliding panel is fully closed.
Keep the
switch pulled for an additional
second.
Press the
switch to the point of resistance
in the direction of arrow 2 and hold it until the sunblinds have opened about 4
in (10 cm).
Pull the
switch repeatedly to the point
of resistance in the direction of arrow 3
until the roller sunblinds are fully closed.
Keep the
switch pulled for an
additional second.
Make sure that the panorama roof
with
power tilt/sliding panel and the roller
sunblinds can be fully opened and closed
again.
If this is not the case, repeat the
steps
above again.
If the panorama roof with power tilt/sliding panel and the roller sunblind cannot be fully opened or closed after resetting, contact a qualified specialist workshop.
See also:
Towing a trailer
There are numerous legal requirements concerning the towing of a trailer, e.g.
speed restrictions. Make sure that your vehicle/ trailer combination complies with
the local requirements not only in ...
Daytime running lamps
Daytime running lamps in Canada
The "daytime running lamps" function is
required by law in Canada. It cannot therefore
be deactivated.
► Turn the light switch to
.
With the e ...
Rear fog lamp
- To switch on the rear fog lamp: turn the
SmartKey in the ignition lock to position 2
or start the engine.
- Turn the light switch to or
or
.
If the light switch is set to or
,
the rear ...