Headlamp cleaning system

The headlamps are cleaned automatically if the "Wipe with washer fluid" function is operated ten times while the lights are on and the engine is running. When you switch off the ignition, the automatic headlamp cleaning system is reset and counting is resumed from 0.

    See also:

    Setting the airflow
    You can set the airflow separately for the driver’s and front-passenger side. Select left airflow 3 or right airflow 5 by turning the COMAND controller and press to confirm. To adjust th ...

    Introduction
    You can establish a Bluetooth® connection to the audio system or to COMAND (see the separate operating instructions). WARNING A driver's attention to the road must always be his/her prima ...

    Blind Spot Assist
    Important safety notes Blind Spot Assist uses a radar sensor system to monitor the areas on both sides of your vehicle. It supports you from speeds of approximately 20 mph (30 km/h). A warning ...