Safety notes

Work improperly carried out on electronic WARNING
Work improperly carried out on electronic components and associated software could cause them to cease functioning. Because the vehicle's electronic components are interconnected, any modifications made may produce an undesired effect on other systems. Electronic malfunctions could seriously impair the operating safety of your vehicle.
Contact an authorized Mercedes-Benz Center for repairs or modifications to electronic components.
Other improper work or modifications on the vehicle could also have a negative impact on the operating safety of the vehicle.
Some safety systems only function when the engine is running. You should therefore never turn off the engine while driving.

Heavy blows against the vehicle underbody or WARNING
Heavy blows against the vehicle underbody or tires/wheels may cause serious damage and impair the operating safety of your vehicle.
Such blows can be caused, for example, by running over an obstacle, road debris or a pothole.
If you feel a sudden significant vibration or ride disturbance, or you suspect that damage to your vehicle has occurred:
- turn on your hazard warning flashers.
- slow down carefully.
- drive with caution to an area which is a safe distance from the road.
Inspect the vehicle underbody and tires/wheels for possible damage. If the vehicle appears unsafe, have it towed to the nearest authorized Mercedes-Benz Center or other qualified maintenance or repair facility for further inspection or repairs.

    See also:

    SmartKey
    Display messages Possible causes/consequences and •► Solutions Key Does Not Belong to Vehicle You have put the wrong SmartKey in the ignition lock. •► Use the correct ...

    Kickdown
    Use kickdown for maximum acceleration. Vehicles for USA: fully depress the accelerator pedal. The transmission shifts to a lower gear depending on the engine speed. Vehicles for Canada: depre ...

    Activating the rear view camera
    Make sure that the SmartKey is in position 2 in the ignition lock. Make sure that the "rear view camera" function is selected in COMAND (see the separate operating instructions for ...