Activating/deactivating the residualheat function

It is possible to make use of the residual heat of the engine to continue heating the stationary vehicle for up to 30 minutes after the engine has been switched off. The heating time depends on the temperature that has been set.

regardless of the airflow setting. The blower will run at a low speed regardless of the airflow setting.

at high temperatures, only the ventilation If you activate the residual heat function at high temperatures, only the ventilation will be activated. The blower runs at medium speed.

► Turn the SmartKey to position 0 in the ignition lock or remove it.
► To activate: press thebutton. button.

The indicator lamp in the lights button lights up.

► To switch off: press the button.

The indicator lamp in the goes button goes out.

automatically: Residual heat is deactivated automatically:

• after about 30 minutes
• when the ignition is switched on
• if the battery voltage drops
• if the coolant temperature is too low

    See also:

    Sliding sunroof
    Important safety notes WARNING   When opening or closing the sliding sunroof, make sure that there is no danger of anyone being harmed by the opening/closing procedure. The sliding sun ...

    Slippery road surfaces
    WARNING The outside temperature indicator is not designed to serve as an ice-warning device and is therefore unsuitable for that purpose. Indicated temperatures just above the freezing poi ...

    Well-proven seat technology with a new design
    Where seat development is concerned, Mercedes-Benz had added a new quality to a well established Mercedes concept, namely padded seat piping - a sophisticated and demanding upholstery technique th ...