Parking lamp/standing lamp
- Switch off the lights.
- Open the hood.
- Remove the headlamp cover ().
- Left-hand headlamp: detach the washer fluid reservoir ().
- Turn housing cover 1 counter-clockwise and pull it out.
- Pull out bulb holder 2.
- Take the bulb out of bulb holder 2.
- Insert the new bulb into bulb holder 2.
- Insert bulb holder 2.
- Align housing cover 1 and turn it clockwise until it engages.
- Left-hand headlamp: fasten the washer fluid reservoir ().
- Install the headlamp cover ().
See also:
Checklist before driving off-road
► Engine oil level: check the engine oil
and
top it up if necessary.
The vehicle can only guarantee a smooth
supply of oil on steep stretches if there is a
sufficient level of engine oil ...
Trailer towing
For vehicles with a trailer tow hitch, the
minimum length for parking spaces is slightly
increased.
If you have attached a trailer to your vehicle,
you should not use Active Parking Assist.
On ...
Making adjustments in 5 mph (Canada: 10 km/h) increments
Briefly press the cruise control
lever
beyond the pressure point, up 1 for a
higher speed or down 2 for a lower speed.
The last speed stored is increased or
reduced. ...