Introduction

COMAND automatically stores the previous destinations for which the route calculation has been started. If the memory is full, COMAND deletes the oldest destination. You can also save a destination from the list of previous destinations in the destination memory. It will be stored there permanently.

    See also:

    Restricting the shift range
    X Press the selector lever to the left towards D–. The automatic transmission shifts down one gear and restricts the shift range to the relevant gear. If the engine exceeds the maximum engine s ...

    SmartKey
    Display messages Possible causes/consequences and •► Solutions Key Does Not Belong to Vehicle You have put the wrong SmartKey in the ignition lock. •► Use the correct ...

    Important safety notes
    WARNING When operating the climate control, the air that enters the passenger compartment through the air vents can be very hot or very cold (depending on the set temperature). This could ca ...