Example of operation
Initial situation
You would like to switch from the vehicle
function to the radio function and select a
station from the station list, for example.
The following operating example describes
how to:
• call up the audio function
• switch on radio mode
• set a station.
Calling up the audio function
Select Audio in the main function bar by
sliding
and turning
the COMAND
controller and press
to confirm.
The basic display of the current audio
operating mode, e.g. audio CD, appears.
Switching to radio mode
Option 1
Press the
function button. The
radio display appears.
Repeated pressing of this function button
switches between radio and the most
recently active audio source.
Option 2
Select Audio again by sliding
the
COMAND controller and press
to
confirm.
The Audio menu appears.
1 Current audio operating mode
2 Main function bar
3 Audio menu
Press
the COMAND controller
and
confirm Radio.
The radio basic display appears with the
waveband last selected.
To set the station: if the display/selection
window is activated in the radio display,
turn
or slide
COMAND
controller.
See also:
Rear seats
Rear seats
...
Maximum load rating
WARNING
Do not overload the tires by exceeding the
specified load limit as indicated on the Tire
and Loading Information placard on the
driver's door B-pillar. Overloading the tires
can ove ...
Standard display
– Press and hold the button on
the
steering wheel until the Trip menu with
odometer 1 and trip odometer 2 is
shown. ...