Opening and closing the side windows

1 Front left

1 Front left
2 Front right
3 Rear right
4 Rear left

The switches for all side windows are located on the driver's door. There is also a switch on each door for the corresponding side window.

The switches on the driver's door take precedence.

from the rear when the override feature for The side windows cannot be operated from the rear when the override feature for the side windows is activated.

ignition lock. Turn the SmartKey to position 1 or 2 in the ignition lock.
To open: press the corresponding switch.
If you press the switch beyond the point To close: pull the corresponding switch.

of resistance, an automatic opening/closing process is started in the If you press the switch beyond the point of resistance, an automatic opening/closing process is started in the corresponding direction. You can stop automatic operation by operating the switch again.

windows after you switch off the engine or You can continue to operate the side windows after you switch off the engine or remove the SmartKey. This function is available for up to five minutes or until the driver's or front-passenger door is opened.

Sunblinds on the rear side windows

switch when the side window is closed. To close fully: pull the corresponding switch when the side window is closed.
switch. To open fully: press the corresponding switch.

doors to close the rear roller sunblinds for You can use the switches on the rear doors to close the rear roller sunblinds for the opposite side.

    See also:

    Removing the ball coupling
    Observe the manufacturer's installation instructions. Press the protective cap into the ball coupling recess. Make sure that the protective cap is firmly in place. ...

    Tire tread
    WARNING Although the applicable federal motor vehicle safety laws consider a tire to be worn when the tread wear indicators (TWI) become visible at approximately 1/16 in (1.6 mm), we recomme ...

    High-beam flasher
    To switch on: turn the SmartKey in the ignition lock to position 1 or 2 or start the engine. Pull the combination switch in the direction of arrow 3. ...