Checking the coolant level
Only check the coolant level when the vehicle is on a level surface and the engine has cooled down.
Turn the SmartKey to position 2 in the ignition lock.
On vehicles with KEYLESS-GO, press the Start/Stop button twice (Y page 145).
•► Check the coolant temperature display in the instrument cluster.
The coolant temperature must be below 158 °F (70 °C).
WARNING
In order to avoid any potentially serious burns:
- use extreme caution when opening the hood if there are any signs of steam or coolant leaking from the cooling system, or if the coolant temperature display indicates that the coolant is overheated.
- do not remove the pressure cap on the coolant reservoir if the coolant temperature is above 158 °F (70 °C). Allow the engine to cool down before removing the cap. The coolant reservoir contains hot fluid and is under pressure.
- using a rag, slowly turn the cap approximately 1/2 turn to relieve excess pressure. If opened immediately, scalding hot fluid and steam will be blown out under pressure.
- do not spill antifreeze on hot engine parts.
Antifreeze contains ethylene glycol which may burn if it comes into contact with hot engine parts.
•► Slowly turn cap 1 half a turn counterclockwise and allow excess pressure to escape.
•► Turn cap 1 further counter-clockwise and remove it.
If the coolant is at the level of marker bar 3 in the filler neck when cold, there is enough coolant in coolant expansion tank 2.
If the coolant is approximately 0.6 in (1.5 cm) above marker bar 3 in the filler neck when warm, there is enough coolant in coolant expansion tank 2.
•► If necessary, add coolant that has been tested and approved by Mercedes-Benz.
•► Replace cap 1 and turn it clockwise as far as it will go.
For further information on coolant.
See also:
Folding the exterior mirrors in or out automatically
This function is only available in vehicles for Canada.
If the "Fold in mirrors when locking" function is activated in the on-board computer
():
the exterior mirrors fold in automatic ...
Windows fogged up on the inside
Activate the cooling with air
dehumidification function .
Activate automatic mode
.
If the windows continue to fog up,
activate the defrosting function.
You should only select this
setti ...
Attaching the roof carrier
– Secure the roof carrier to roof rails 1.
– Observe the manufacturer's installation
instructions. ...