Vehicle remote opening
If you have unintentionally locked your vehicle (e.g. the SmartKey is still in the vehicle) and a replacement SmartKey is not available, the vehicle can be opened by a Mercedes-Benz Customer Assistance Center.
The vehicle can be opened remotely up to four days after the ignition was last switched off.
•► Contact the following service hotlines:
- USA: Mercedes-Benz Customer
Assistance Center under 1-800-FORMERCedes (
1-800-367-6372) or
1-888-990-9007
- Canada: Customer Service at
1-888-923-8367
You will be asked for your password.
•► Return to your vehicle at the time agreed upon with the Mercedes-Benz Customer Assistance Center.
•► Pull the trunk handle/tailgate handle for at least 20 seconds until the indicator lamp in the SOS button (Y page 297) flashes.
The Connecting Call message appears on the multifunction display.
Alternatively, the vehicle can also be opened via the Internet or an iPhone in the "Owners Online" section using your ID number and password.
Vehicle remote unlocking is only possible if the corresponding mobile phone network is accessible.
The SOS button flashes and the Connecting Call message appears in the multifunction display to confirm that the command for vehicle remote unlocking has been received.
If you pull the trunk handle for more than 20 seconds before receiving authorization for remote unlocking, you must wait 15 minutes before you can pull the trunk lid handle again.
See also:
Setting the temperature
You can set the temperature separately for
the driver’s and front-passenger side.
Select left temperature display 1 or right
temperature display 7 in the airconditioning
function bar by turnin ...
Coolant temperature display
WARNING
Driving when your engine is overheated can
cause some fluids which may have leaked into
the engine compartment to catch fire. You
could be seriously burned.
Steam from an overheate ...
Copying data to a storage medium
Insert an SD card into the SD card slot
or
Insert a USB stick into the socket on the
side in the glove box.
Select Vehicle in the main function bar by
turning the COMAND controller and
p ...
