Opening and closing

Overhead control panel

Overhead control panel

1. To open
2. To open
3. To close

•► Turn the SmartKey to position 1 or 2 in the ignition lock.

•► Press or pull the corresponding direction. switch in the corresponding direction.

If you press the the switch beyond the point of resistance, an automatic opening/ closing process is started in the corresponding direction. You can stop automatic operation by operating the switch again.

    See also:

    BAS PLUS (Brake Assist System Plus)
    BAS PLUS is only available in vehicles equipped with DISTRONIC PLUS. Observe the "Important safety notes" section. At speeds above approximately 20 mph (30 km/h), BAS PLUS assists ...

    Introduction
    SRS consists of: the SRS warning lamp air bags air bag control unit (with crash sensors) Emergency Tensioning Devices belt force limiters SRS reduces the risk of occupants coming into ...

    Problems with the rear window defroster
    The rear window defroster has deactivated itself prematurely or cannot be activated. Switch off any consumers that are not required, e.g. reading lamps or interior lighting. When the battery ...