Activating the HOLD function
Make sure that the activation
conditions
are met.
Depress the brake pedal.
Quickly depress the brake pedal
further
until HOLD display 1 appears in the
multifunction display.
The HOLD function is activated. You can
release the brake pedal.
If depressing the brake pedal
the first
time does not activate the HOLD function,
wait briefly and then try again.
WARNING
The vehicle's brakes are applied when the
HOLD function is activated. For this reason,
deactivate the HOLD function if the vehicle is
to be set in motion by other means (e.g. in a
car wash or by towing).
See also:
Activating/deactivating the radar
sensor system
The following systems are switched off when
the radar sensor system is deactivated:
• DISTRONIC PLUS
• BAS PLUS
• PRE-SAFE® Brake
• Blind Spot Assist
• Active Blind Spot Assist
USA on ...
Replacing the windshield wiper blades
Removing the wiper blades
► Remove the SmartKey from the ignition
lock.
► Fold the wiper arm away from the
windshield.
► Press both release clips 2.
► Fold wiper blade ...
Ashtray in the front-compartment
center console
To open: slide cover 1 forwards until it
engages.
To remove insert: hold insert 3 by the
ribbing at the sides and lift it up 2 and out.
To re-install the insert: press insert 3
into the h ...