Switching on/off

WARNING
Repeatedly setting the seat heating to level 3 may result in excessive seat temperatures.
The health of passengers that have limited temperature sensitivity or a limited ability to react to excessively high temperatures may be affected or they may even suffer burn-like injuries. Therefore, do not use seat heating level 3 repeatedly.

The three red indicator lamps in the button indicate the heating level you have selected.

low, the seat If the battery voltage is too low, the seat heating may switch off.

Driver's and front-passenger seat
Driver's and front-passenger seat

The system automatically switches down from level 3 to level 2 after approximately eight minutes.

The system automatically switches down from level 2 to level 1 after approximately ten minutes.

The system automatically switches off approximately 20 minutes after it is set to level 1.

in position 1 or 2 in the ignition lock. Make sure that the SmartKey is in position 1 or 2 in the ignition lock.
repeatedly until the desired heating level is set. To switch on: press button 1 repeatedly until the desired heating level is set.
1 repeatedly until all the indicator lamps go out. To switch off: press button 1 repeatedly until all the indicator lamps go out.

    See also:

    LATCH-type (ISOFIX) child seat anchors in the rear
    WARNING Children that are too large for a child restraint must travel in seats using normal seat belts. Position shoulder belt across the chest and shoulder, not face or neck. In order to att ...

    Coupling up a trailer
    Observe the maximum permissible trailer dimensions (width and length). Most U.S. states and all Canadian provinces require by law: safety chains between the towing vehicle and the trailer. The ch ...

    General information
    If COMAND is equipped with a navigation system and has GPS reception, COMAND automatically sets the time and date. You can also adjust the time yourself in 30-minute increments, but the date c ...