Opening and closing

Overhead control panel
Overhead control panel

1 To open
2 To open
3 To close

1 or 2 in the ignition lock. Turn the SmartKey to position 1 or 2 in the ignition lock.

switch in the corresponding Press or pull the direction. switch in the corresponding direction.

switch beyond the If you press the point of resistance, an automatic opening/closing process is started in the switch beyond the point of resistance, an automatic opening/closing process is started in the corresponding direction. You can stop automatic operation by operating the switch again.

    See also:

    SmartKey
    Display messages Possible causes/consequences and •► Solutions Key Does Not Belong to Vehicle You have put the wrong SmartKey in the ignition lock. •► Use the correct ...

    Vehicles with manual transmission
    •► Shift to either first gear or reverse gear R.•► Turn the SmartKey to position 0 in the ignition lock and remove it. The immobilizer is activated.•► Apply the parking brake f ...

    Trip computer "From start" or "From reset"
    The values in the From Start submenu are calculated from the start of a journey, while the values in the From Reset submenu are calculated from the last time the submenu was reset. – Press th ...