Snow chains

For safety reasons, Mercedes-Benz recommends that you only use snow chains that have been specially approved for your vehicle by Mercedes-Benz, or are of a corresponding standard of quality.

Vehicles with the Adaptive Damping Vehicles with the Adaptive Damping System (ADS): do not drive in ADS SPORT mode if snow chains have been mounted.
The vehicle may otherwise be damaged.

There is not enough space for snow There is not enough space for snow chains on some wheel sizes. Observe the information under "Tires and wheels" in the "Technical Data" section to avoid damage to the vehicle or the wheels.

- only use snow chains when driving on roads completely covered by snow. Do not exceed the maximum permissible speed of 30 mph (50 km/h). Remove the snow chains as soon as possible when you are no longer driving on snow-covered roads.
- local regulations may restrict the use of snow chains. Applicable regulations must be observed if you wish to mount snow chains.
- snow chains must not be mounted on emergency spare wheels.

If you intend to mount snow chains, please bear the following points in mind:
- you may not attach snow chains to all wheel-tire combinations; see the information under "Wheel and tire combinations" in the "Wheels and tires" section.
- mount snow chains only in pairs and only on the rear wheels. Observe the manufacturer's installation instructions.

If snow chains are mounted on the front If snow chains are mounted on the front wheels, the snow chains could grind against the bodywork or components of the chassis. This could result in damage to the vehicle or the tires.

Vehicles with steel wheels: if you wish Vehicles with steel wheels: if you wish to mount snow chains on steel wheels, make sure that you remove the respective wheels' hubcaps first. The hubcaps may otherwise be damaged.

You may wish to deactivate You may wish to deactivate ESP® when pulling away with snow chains mounted. This way you can allow the wheels to spin in a controlled manner, achieving an increased driving force (cutting action).

    See also:

    Entering a destination from the list of last destinations
    To activate navigation mode: press the function button once or twice. To show the menu: press the COMAND controller. Select Destination in the navigation system menu bar by turning t ...

    Making adjustments in 1 mph (Canada: 1 km/h) increments
    Briefly press the cruise control lever to the pressure point, up 1 for a higher speed or down 2 for a lower speed. The last speed stored is increased or reduced. ...

    Problems with Night View Assist Plus
    Problem Possible causes/consequences and - Solutions The picture quality of Night View Assist Plus has deteriorated. The windshield wipers are smearing the windshield. ...