Windshield washer system and headlamp cleaning system

The washer fluid reservoir is used for both the windshield washer system and the headlamp cleaning system.

Vehicle components and their service Vehicle components and their service products must match. You should, therefore, only use products that have been tested and approved by Mercedes-Benz.
Information on tested and approved products can be obtained at any authorized Mercedes-Benz Center or on the Internet at http://www.mbusa.com (USA only).

Washer solvent/antifreeze is highly WARNING
Washer solvent/antifreeze is highly flammable. Do not spill washer solvent/antifreeze on hot engine parts, because it may ignite and burn. You could be seriously burned.

At temperatures below freezing: always At temperatures below freezing: always fill the washer fluid reservoir with a mix of water and windshield washer concentrate (e.g. MB WinterFit). There is otherwise a risk of damaging the windshield washer system/headlamp cleaning system.

Only use washer fluid concentrate which Only use washer fluid concentrate which is suitable for plastic lenses. Unsuitable washer fluid concentrate could damage the plastic lenses of the headlamps.

Do not add distilled or de-ionized water to Do not add distilled or de-ionized water to the washer fluid container. Otherwise, the level sensor may be damaged.

Add windshield washer concentrate, e.g. MB SummerFit, to the washer fluid all Add windshield washer concentrate, e.g. MB SummerFit, to the washer fluid all year round.

Example: washer fluid reservoir
Example: washer fluid reservoir

– Mix the windshield washer fluid in a container beforehand.
– At temperatures above freezing: fill the washer fluid reservoir with a mix of water and windshield washer concentrate (e.g. MB SummerFit).
– At temperatures below freezing: fill the washer fluid reservoir with a mix of water and windshield washer concentrate (e.g. MB WinterFit). Adapt the mixing ratio to the outside temperature. For information on the mixing ratio.
– To open: pull cap 1 upwards by the tab.
– Add the premixed washer fluid.
– To close: press cap 1 onto the filler neck until it engages.

    See also:

    Restoring the factory settings
    Press the and buttons simultaneously for approximately six seconds until the battery check lamp flashes twice. ...

    Important notes on the use of KEYLESSGO
    • The KEYLESS-GO key can be used like a conventional key. • You can combine KEYLESS-GO functions with those of a conventional key, e.g. unlock with KEYLESS-GO and lock with the & button. • A ...

    Running the Numbers
    Thanks to diesel engines' higher efficiency, the Bluetec achieves nearly the same EPA ratings as a Cadillac Escalade Hybrid. The figures are 27 percent better overall than those of the gas GL450, ...