Warning and display messages in the multifunction display

– Activate ATTENTION ASSIST using the onboard

– Activate ATTENTION ASSIST using the onboard computer (Y page 232).
Symbol 1 appears in the multifunction display.

– If necessary, take a break.
– Press to confirm the or message. to confirm the message.

On long journeys, take regular breaks in good time to allow yourself to rest properly. If you do not take a break and ATTENTION ASSIST still detects typical indicators of fatigue or increasing lapses in concentration, you will be warned again after 15 minutes at the earliest.

ATTENTION ASSIST is reset when you continue your journey and starts assessing your tiredness again if:
- you switch off the engine.
- you take off your seat belt and open the driver's door, e.g. for a change of drivers or to take a break.

    See also:

    Cleaning the display
    Before cleaning the display, make sure that it is switched off and has cooled down. Clean the display surface using a commercially-available microfiber cloth and TFT/LCD display cleaner. Dr ...

    Blind Spot Assist
    Important safety notes Blind Spot Assist uses a radar sensor system to monitor the areas on both sides of your vehicle. It supports you from speeds of approximately 20 mph (30 km/h). A warning ...

    Setting the rear-compartment airflow using the rear control panel
    Turn the SmartKey to position 2 in the ignition lock. To increase/reduce: press rocker switch 14 up or down. ...