Storing settings
With the memory function, you can store up to three different settings, e.g. for three different people.
The following settings are stored as a single
memory preset:
- position of the seat, backrest and head
restraint
- driver's side: steering wheel position
- driver's side: position of the exterior
mirrors on the driver's and front-passenger
sides
WARNING
Do not activate the memory function while
driving. Activating the memory function while
driving could cause the driver to lose control
of the vehicle.
- Adjust the seat.
- On the driver's side, adjust the steering
wheel and the exterior mirrors.
- Press memory button M and one of the
storage position buttons 1, 2 or 3 within
three seconds.
The settings are stored in the selected preset position. A tone sounds when the settings have been completed.
See also:
Adjusting the head restraint heightelectrically
► To adjust the head restraint height:
slide
the switch for head restraint adjustment up or down in the direction of
the arrow. ...
Stowage well under the trunk floor
The TIREFIT kit, the vehicle tool kit, etc. are
located in the stowage compartment.
To open: pull handle 1
upwards.
Hook handle 1 into rain trough
2.
Unhook the handle before again
b ...
Problems with the seat ventilation
The seat ventilation has switched off
prematurely or cannot be switched on. The
vehicle's electrical system voltage is too low
because too many electrical consumers are
switched on.
- Switch ...