Changing a wheel
Flat tire
The "Roadside Assistance" section contains information and notes on how to deal with a flat tire. It also provides instructions on changing a wheel or mounting the spare wheel/emergency spare wheel.
Interchanging the wheels
WARNING
Rotate front and rear wheels only if the tires
are of the same dimension.
If your vehicle is equipped with mixed-size
tires (different tire dimensions front vs. rear),
tire rotation is not possible.
WARNING
Have the tightening torque checked after
changing a wheel. The wheels could come
loose if they are not tightened to a torque of
110 lb-ft (150 Nm).
Only use genuine Mercedes-Benz wheel bolts
specified for your vehicle's rims.
The wear patterns on the front and rear tires differ, depending on the operating conditions.
Rotate the wheels before a clear wear pattern has formed on the tires. Front tires typically wear more on the shoulders and the rear tires in the center.
If your vehicle's tire configuration allows, you can rotate the wheels according to the intervals in the tire manufacturer's warranty book in your vehicle documents. If this is not available, the tires should then be replaced every 3000 to 6000 miles (5000 to 10,000 km), or earlier if the tire wear requires this. Do not change the direction of wheel rotation.
Clean the contact surfaces of the wheel and the brake disc thoroughly every time a wheel is interchanged. Check the tire pressures.
Information on changing a wheel and mounting the spare wheel.
On vehicles equipped with a tire pressure monitor, electronic components are located in the wheel.
Tire-mounting tools should not be used near the valve. This could damage the electronic components.
Always have the tires changed at a qualified specialist workshop, e.g. an authorized Mercedes-Benz Center.
Direction of rotation
Tires with a specified direction of rotation have additional benefits, e.g. if there is a risk of hydroplaning. You will only gain these benefits if the correct direction of rotation is maintained.
An arrow on the sidewall of the tire indicates its correct direction of rotation.
You may mount a spare wheel/emergency spare wheel against the direction of rotation.
Observe the time restriction on use as well as the speed limit specified on the spare wheel/ emergency spare wheel.
Storing wheels
Store wheels that are not being used in a cool, dry and preferably dark place. Protect the tires from oil, grease, gasoline and diesel.
Cleaning the wheels
WARNING
Do not use power washers with circular-jet
nozzles (dirt grinders) to clean your vehicle, in
particular the tires. You could otherwise
damage the tires and cause an accident.
See also:
Engine emergency off
If the engine cannot be switched off as
described, observe the following procedure:
Take the fuse allocation chart out of the
vehicle document wallet.
Search for “Emergency engine shutdown”
...
Load bearing index
The load bearing index (also load index) is a
code that contains the maximum load bearing
capacity of a tire. ...
EBD (electronic brake force distribution)
Observe the "Important safety notes"
section.
EBD monitors and controls the brake
pressure on the rear wheels to improve
driving stability while braking.
WARNING
If EBD has malfu ...