Removing a wheel
► Unscrew the uppermost wheel bolt
completely.
► Screw alignment bolt 1 into the thread
instead of the wheel bolt.
► Unscrew the remaining wheel bolts fully.
Do not place wheel bolts in sand or on a
dirty surface. The bolt and wheel hub
threads could otherwise be damaged when
you screw them in.
► Remove the wheel.
See also:
Additives
Only use DEF in accordance with ISO
22241. Do not use additives with DEF and
do not dilute DEF with water. This may
destroy the BlueTEC exhaust gas
aftertreatment system. ...
Entering an intermediate stop
Introduction
When route guidance is active, you can enter
an intermediate stop. Intermediate stops can
be predefined destinations from the following
categories that COMAND offers for selection: ...
Headlamps fogged up on the inside
The headlamps may fog up on the inside if
there is high atmospheric humidity.
- Drive with the headlamps switched on.
The level of moisture diminishes,
depending on the length of the journey and ...