Inserting the mounting elements intothe loading rail

You can slide mounting element 2 in loading

You can slide mounting element 2 in loading rail 1 to various detents and secure it. These detents are marked and positioned at 5-cm intervals along loading rail 1.

You can turn mounting element 2 of loading rail : to four positions:

To release the cargo tie-down To lock the mounting element
ring, the To release the cargo tie-down ring, the inertia reel or the telescopic rod
To push the mounting element to To remove the mounting element
the To push the mounting element to the next detent

Turn mounting element 2 to ► Insert mounting element 2 into loading.
Insert mounting element 2 into loading rail 1.
Turn mounting element 2 to you feel it clearly engage in loading rail 1. until you feel it clearly engage in loading rail 1.

    See also:

    Cruise control lever
    1 To store the current speed or a higher speed 2 To store the current speed or a lower speed 3 To deactivate cruise control 4 To store the current speed or to call up the last stored speed Wh ...

    Service and literature
    Your vehicle is covered under the terms of the warranties printed in the Service and Warranty Information booklet. Your authorized Mercedes-Benz Center will exchange or repair any defective pa ...

    Problems with the windshield wipers
    The windshield wipers are obstructed Leaves or snow, for example, may be obstructing the windshield wiper movement. The wiper motor has been deactivated. For safety reasons, you should remove t ...