Setting the specified minimum distance

You can set the specified minimum distance for DISTRONIC by varying the time span between one and two seconds. This time span determines the distance that DISTRONIC should maintain from the vehicle in front, depending on the road speed. You can see this distance in the multifunction display.

WARNING It is up to the driver to exercise discretion to 
It is up to the driver to exercise discretion to select the appropriate setting given road conditions, traffic, driver's preferred driving style and applicable laws and driving recommendations for safe following distance.

► To increase: turn thumbwheel 2 towards

► To increase: turn thumbwheel 2 towards 3.

DISTRONIC then maintains a greater distance between your vehicle and the vehicle in front.

► To decrease: turn thumbwheel 2 towards 1.

DISTRONIC then maintains a shorter distance between your vehicle and the vehicle in front.

minimum distance to the vehicle in front as Make sure that you maintain the minimum distance to the vehicle in front as required by law. Adjust the distance to the vehicle in front if necessary.

    See also:

    Activating/deactivating the residual heat function
    It is possible to make use of the residual heat of the engine to continue heating the stationary vehicle for up to 30 minutes after the engine has been switched off. The heating time depends on th ...

    Information about driving abroad
    Converting to symmetrical low beam when driving abroad: switch the headlamps to symmetrical low beam in countries in which traffic drives on the opposite side of the road to the country where ...

    Automatic anti-glare mirrors
    WARNING If incident light from headlamps is prevented from striking the sensor in the rear-view mirror, for instance, by luggage piled too high in the vehicle, the mirror's automatic antiglar ...