Turn signals

1 High-beam headlamps

1 High-beam headlamps
2 Right turn signal
3 High-beam flasher
4 Left turn signal

To indicate briefly: press the combination switch briefly to the pressure point in the direction of arrow 2 or 4.

The corresponding turn signal flashes three times.

To indicate: press the combination switch beyond the pressure point in the direction of arrow 2 or 4.

To switch on the high-beam headlamps:

turn the SmartKey in the ignition lock to position 2 or start the engine.

Turn the light switch to .

Press the combination switch beyond the pressure point in the direction of arrow 1.

The instrument indicator lamp in the instrument cluster lights up.

To switch off the high-beam headlamps: move the combination switch back to its normal position.

The instrument indicator lamp in the instrument cluster goes out.

    See also:

    General notes
    USA only: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. this device must ...

    Replacing the windshield wiper blades
    Removing the wiper blades Remove the SmartKey from the ignition lock or turn it to position 0 (KEYLESS-GO). Fold the wiper arm away from the windshield until it engages. Set the wiper blade ...

    Power washers
    WARNING Do not use power washers with circular-jet nozzles (dirt grinders) to clean your vehicle, in particular the tires. You could otherwise damage the tires and cause an accident. Always ...