Daytime running lamps
Daytime running lamps in Canada
The "daytime running lamps" function is required by law in Canada. It cannot therefore be deactivated.
► Turn the light switch to
.
With the engine running: depending on the ambient light, the daytime running lamps or the low-beam headlamps are switched on.
When the low-beam headlamps are
activated, the 
indicator lamp on
the
light switch and the 
indicator lamp
in
the instrument cluster light up.
When the engine is running and the vehicle is stationary or if the parking brake is applied: if you move the selector lever from a drive position to P, the daytime running lamps/ low-beam headlamps go out after three minutes.
When the engine is running, the vehicle is
stationary and in high ambient light
brightness: if you turn the light switch
to 
, the daytime running lamps and
the
parking lamps are switched on.
Daytime running lamps in the USA
In the USA, the daytime running lamps are deactivated upon delivery from the factory.
► To activate the daytime running lamps: activate the daytime running lamps function in the on-board computer.
► Turn the light switch to
.
With the engine running: depending on the ambient light, the daytime running lamps or the low-beam headlamps are switched on.
When the low-beam headlamps are
activated, the 
indicator lamp on
the
light switch and the 
indicator lamp
in
the instrument cluster light up.
If the engine is running and you turn the light
switch to or
, the manual settings
take precedence over the daytime running
lamps.
See also:
Turn signal lamps/side marker lamps
Switch off the lights.
Open the hood.
Remove the headlamp cover ().
Left-hand headlamp: detach the washer fluid reservoir ().
Turn bulb holder 1 or 2 counterclockwise and pull it out.
W ...
Before changing a fuse
Park the vehicle and apply the parking
brake.
Switch off all electrical consumers.
Remove the SmartKey from the ignition
lock.
The fuses are located in various fuse boxes:
...
Capacities
...