Belt warning for the driver and frontpassenger
Regardless of whether the driver and front passenger have fastened their seat belts already, the seat belt warning lamp lights up for 6 seconds after every engine start. It then goes out if the driver and the front passenger have fastened their seat belts.
If the driver's seat belt is not fastened after the engine is started, an additional warning tone will sound. The warning tone goes out after approximately six seconds or once the driver's seat belt is fastened.
If the driver or front passenger have not fastened their seat belt after 6 seconds and the doors are closed, the seat belt warning lamp lights up.
• until the driver or the front passenger
have
fastened their seat belts
• if a vehicle speed of 15 mph(25 km/h) is
exceeded once, a warning tone with
increasing intensity sounds additionally for
a maximum of 60 seconds or until the driver
or front passenger have fastened their seat
belts.
If the driver or front passenger undo their seat belts during the journey, the seat belt warning lamp lights up and the warning tone sounds again.
The warning tone ceases even if the driver or front passenger have still not fastened their seat belt after 60 seconds. The seat belt warning lamp stops flashing but continues to be lit.
Once the vehicle is stationary, the warning tone is reactivated and the seat belt warning lamp starts to flash again if the vehicle speed exceeds 15 mph(25 km/h) once.
The seat belt warning lamp only goes out if:
• both the driver and the front passenger
have fastened their seat belts.
or
• the vehicle is stationary and a door is
open.
For more information on the seat belt warning lamp, see "Warning and indicator lamps in the instrument cluster, seat belt".
See also:
Cup holder in the rear seat armrest
Do not sit on or support your
body weight
on the rear seat armrest when it is folded
down, as you could otherwise damage it.
Close the cup holder before
folding the
rear seat armrest up. ...
Checking the coolant level
Only check the coolant level when the vehicle is on a level surface and the engine
has cooled down.
Turn the SmartKey to position 2 () in the ignition lock. On
vehicles with KEYLESS-GO, press ...
Selecting a station
Selecting a station using the station
search function
Turn or slide
the COMAND
controller while the display/selection
window in the radio display is active.
Station search scans up or down ...