Cleaning the trailer tow hitch
The ball coupling must be cleaned if it becomes dirty or corroded.
- Remove rust on the ball of the ball coupling, e.g. with a wire brush.
- Remove dirt with a clean, lint-free cloth or a brush.
- After cleaning, lightly grease the ball of the ball coupling again.
- Check that the vehicle's trailer tow hitch is working properly.
Observe the note on care provided by the trailer manufacturer.
You can also have the maintenance work on the ball coupling and the trailer
tow hitch carried out by a qualified specialist workshop.
Environmental note
Dispose of rags soaked in oil and grease in an environmentally responsible manner.
See also:
Cargo tie-down rings
Observe the following notes on securing loads:
secure the load using the cargo tie down rings.
do not use elastic straps or nets to secure a load, as these are only intended
as an anti-slip p ...
Brake fluid
WARNING
Over a period of time, the brake fluid absorbs
moisture from the air; this lowers its boiling
point.
If the boiling point of the brake fluid is too low,
vapor pockets may form in the ...
Rear seat head restraints
WARNING
For safety reasons, always drive with the rear
head restraints in the upright position when
the rear seats are occupied.
Keep the area around head restraints clear of
articles (e.g. c ...