Tail lamp
- Switch off the lights.
- Open the cargo compartment.
- Open the side trim panel ().
- Pull out connector 2.
- Press retaining lugs 1 simultaneously in the direction of the arrow and pull the bulb holder out.
Bulb holder without LED turn signal lamp
- Tail lamp/brake lamp
- Turn signals
- Backup lamp
- ear fog lamp/tail lamp
- Side marker lamp
- Lightly press the corresponding bulb into the holder, turn it counter-clockwise and remove it from the bulb holder.
- Insert the corresponding new bulb into the bulb holder and turn it clockwise.
- Attach the bulb holder and press firmly. The retaining lugs on the bulb holder engage audibly.
- Insert the connector.
- Close the side trim panel ().
See also:
Restoring the factory settings
Press the
and
buttons simultaneously for
approximately six seconds until the battery check lamp flashes twice. ...
Correct driver's seat position
Correct driver's seat position
Observe the safety guidelines on seat
adjustment.
Check whether you have adjusted seat 3
properly.
Electrical seat adjustment.
When adjusting the seat, make s ...
Important safety notes
The coolant is a mixture of water and
antifreeze/corrosion inhibitor. It performs
the following tasks:
• corrosion protection
• antifreeze protection
• raising the boiling point
The engine coo ...