Opening and closing

Overhead control panel

Overhead control panel

  1. To open
  2. To open
  3. To close
  4. Turn the SmartKey to position 1 or 2 in the ignition lock.
  5. Press or pull the in the corresponding direction. switch in the corresponding direction.

the point of resistance, an automatic opening/ closing process is started in the If you press the the point of resistance, an automatic opening/ closing process is started in the switch beyond the point of resistance, an automatic opening/ closing process is started in the corresponding direction. You can stop automatic operation by operating the switch again.

    See also:

    Changing gear
    The automatic transmission shifts to the individual gears automatically when it is in transmission position D. This automatic gearshifting behavior is determined by: - a possible limitation of ...

    Using the SmartKey
    The SmartKey must be close to the driver's door handle. Point the tip of the SmartKey at the driver's door handle. Press and hold the button until the side windows and the sliding sunro ...

    Storing the current speed or calling up a stored speed
    WARNING The set speed stored in memory should only be set again if prevailing road conditions and legal speed limits permit. Possible acceleration or deceleration differences arising from r ...