Resetting the side windows
You must reset each side window if a side window can no longer be closed fully.
- Close all the doors.
- Turn the SmartKey to position 1 or 2 in the ignition lock.
- Pull the corresponding switch on the door control panel until the side window is completely closed. ()
- Hold the switch for an additional second.
If the side window opens again slightly:
- Immediately pull the corresponding switch on the door control panel until the side window is completely closed ().
- Hold the switch for an additional second.
- If the corresponding side window remains closed after the button has been released, the side window has been reset correctly. If this is not the case, repeat the steps above again.
See also:
Activating/deactivating the residual
heat function
The residual heat function is only available in
Canada
It is possible to make use of the residual heat
of the engine to continue heating the
stationary vehicle for up to 30 minutes after
the ...
Using the rear center seat belt
If the left-hand rear seat backrest is folded down and back up again, the rear
center seat belt may lock. The seat belt can then not be pulled out.
To release the rear center seat belt: pull out ...
Maximum gradient-climbing capability
If the load on the front axle is reduced when pulling away on a steep uphill
slope, the front wheels have a tendency to spin. 4ETS recognizes this and brakes
the wheels accordingly. The rear wh ...