Locking the vehicle (mechanical key)

If the vehicle can no longer be locked with the SmartKey, use the mechanical key.

  • Open the driver's door.
  • Close the front-passenger door, the rear doors and the tailgate.
  • Press the locking button ().
  • Check whether the locking knobs on the front-passenger door and the rear doors are still visible. Press down the locking knobs by hand, if necessary.
  • Close the driver's door.
  • Take the mechanical key out of the SmartKey ().
  • Insert the mechanical key into the lock of the driver's door as far as it will go.

  • Turn the mechanical key clockwise as far as it will go to position 1.
  • Turn the mechanical key back and remove it.
  • Make sure that the doors and the tailgate are locked.
  • Insert the mechanical key into the SmartKey.

The antitheft alarm system is not armed. If you lock the vehicle as described above, the fuel filler flap is not locked. The antitheft alarm system is not armed.

    See also:

    Introduction to destination entry
    WARNING For safety reasons, only enter a new destination when the vehicle is stationary. You could otherwise be distracted from the traffic conditions, cause an accident and injure yoursel ...

    Switching the city model on/off
    When the city model is switched on, the map shows buildings as 3D models. The city model is only shown in the "3D map" map orientation. It is available for map scales 50 m and 100 ...

    Servicing the brakes
    If the red brake warning lamp lights up in the instrument cluster and you hear a warning tone while the engine is running, the brake fluid level may be too low. Observe additional warning messag ...