Replacing the wiper blades
Moving the wiper blades to a vertical position
Vehicles without KEYLESS-GO
Turn the SmartKey to position 1 or 2 in the
ignition lock.
Set the windshield wipers to
position
.
When the wiper arms have reached a
vertical position, turn the SmartKey to
position 0 and remove it from the ignition
lock.
Vehicles with KEYLESS-GO
Switch off the engine.
Remove your foot from the brake pedal.
Set the windshield wipers to
position
.
Press the Start/Stop button repeatedly
until the windshield wipers start.
When the wiper arms have reached a
vertical position, press the Start/Stop
button.
Removing the wiper blades
Fold the wiper arm away from the
windshield until it engages.
Set the wiper blade at right angles to the
wiper arm.
Remove the wiper blade from the retaining
pin on the wiper arm in the direction of the
arrow.
Installing the wiper blades
Push the new wiper blade onto the
retaining pin on the wiper arm in the
opposite direction to the arrow.
Make sure that the wiper blade slides fully onto the retaining pin on the wiper arm.
Turn the wiper blade parallel to the wiper
arm.
Fold the wiper arm back onto the
windshield.
See also:
Important safety notes
If a tire pressure monitor system is installed,
the vehicle's wheels have sensors that
monitor the tire pressures in all four tires. The
tire pressure monitor warns you when the
pressure drops ...
Introduction
COMAND automatically stores the previous
destinations for which the route calculation
has been started. If the memory is full,
COMAND deletes the oldest destination. You
can also save a destin ...
Load index
Tire data is vehicle-specific and may
deviate from the data in the example.
In addition to the load bearing index, load
index 1 may be imprinted after the letters
that identify speed index 6 ...