Switching the ECO function on/off

The ECO start/stop function switches the engine off automatically if the vehicle is stopped under certain conditions. When pulling away again, the engine starts automatically. You can switch the ECO start/stop function on and off using COMAND.

If you switch the ECO start/stop function off using COMAND, the function is switched on again automatically when you switch the ignition off and on again.

To switch the ECO start/stop function

on/off: select Vehicle in the main To switch the ECO start/stop function on/off: select Vehicle in the main function bar by sliding the COMAND controller and press and turning to confirm. the COMAND controller and press The main area is active. to confirm.

The main area is active.

or Select the ECO function by sliding turning  the COMAND controller and or turning press  to confirm. the COMAND controller and press The ECO start/stop function is switched on to confirm.

The ECO start/stop function is switched on and off alternately.

    See also:

    Example: step 1 to 3
    The following table shows examples on how to calculate total and cargo load capacities with varying seating configurations and number and size of occupants. The following examples use a load l ...

    LATCH-type (ISOFIX) child seat anchors in the rear
    WARNING Children that are too large for a child restraint must travel in seats using normal seat belts. Position shoulder belt across the chest and shoulder, not face or neck. In order to a ...

    Tire tread
    WARNING Although the applicable federal motor vehicle safety laws consider a tire to be worn when the tread wear indicators (TWI) become visible at approximately 1/16 in (1.6 mm), we recomme ...