Storing a phone number which has not yet been stored
Introduction
For incoming calls from a person who is not in the address book, COMAND displays the phone number in the call list. You can save this entry.
Storing as a new entry in the address book
Open a call list and select an entry.
Select Options by sliding
the
COMAND controller and press
to
confirm.
Select Save Number and press
to
confirm.
Select New Entry and press
to confirm.
Select a category for the number, e.g.
Home, and press to confirm.
Select a category for the phone, e.g.
Cellular Phone Number, and press
to
confirm.
If you have not entered the phone number
in a number and telephone category,
the
icon will appear in the
display.
Select Next (save) and press
to
confirm.
An input menu with data fields is shown.
The data field for the telephone number is filled in automatically.
1 Data fields for surname, first name and company
2 Number category
3 Phone category
4 The data field for the telephone number is filled in automatically.
5 Two-line character bar
Proceed as described under "Entering
characters" in the "Entering characters in
the address and phone books" section.
Adding a phone number to an address book entry
Open a call list and select an entry.
Select Options by sliding
the
COMAND controller and press
to
confirm.
Select Save Number and press
to
confirm.
Select Add and press
to
confirm.
The search menu for address book entries appears.
Search for the desired entry.
Press
when you have finished
searching.
Select a category for the number, e.g.
Home, and press to confirm.
Select a category for the phone, e.g.
Cellular Phone Number, and press
to
confirm.
Select Next (save) and press
to
confirm.
COMAND stores the data if there are fewer than five numbers assigned to the entry you are searching for.
You will see a message to this effect.
If five numbers are stored for the entry you are searching for, a prompt will appear asking whether you wish to overwrite one of the existing numbers.
Select Yes or No and press
to
confirm.
If you select Yes, a selection list with the five existing numbers appears.
If you select No, the process will be aborted.
Select the number to be overwritten in the
list by turning
the COMAND
controller
and press
to confirm.
COMAND overwrites the selected number with the new data.
See also:
Switching on/off
The three red indicator lamps in the button
indicate the heating level you have selected.
If the battery voltage is too low, the seat
heating may switch off.
One or more of the indicator lamp ...
Restarting the tire pressure monitor
WARNING
It is the driver's responsibility to set the tire
pressure to the recommended cold tire
pressure. Underinflated tires affect the ability
to steer or brake the vehicle. You might lose ...
Entering a destination from the list of
last destinations
To activate navigation mode: press the
function button once or twice.
To show the menu: press
the COMAND
controller.
Select Destination in the navigation
system menu bar by turning t ...