Setting the map to the vehicle position, intermediate stop or destination position
Centering the map on the vehicle position
To show the menu: press 
the COMAND
controller.
Select Position in the navigation system
menu bar by sliding 
and turning 
the COMAND controller and press to
confirm.
Select Vehicle Position Map and press
to confirm or, if the crosshair is
shown,
press the 
back button.
This hides the crosshair.
Centering on an intermediate stop
This function requires that a route to an intermediate stop has been calculated.
To show the menu: press
the COMAND
controller.
Select Position in the navigation system
menu bar by sliding and turning
the COMAND controller and press to
confirm.
Select Stopover Map and press
to
confirm.
The crosshair is centered on the destination.
Centering on the destination
This function requires that a route to a destination has been calculated.
To show the menu: press
the COMAND
controller.
Select Position in the navigation system
menu bar by sliding and turning
the COMAND controller and press to
confirm.
Select Destination Map and press
to
confirm.
The crosshair is centered on the destination.
See also:
Important safety notes
WARNING
When expanding the cargo volume, always
fold the seat backrests fully forward.
Unless you are transporting cargo, the seat
backrests must remain properly locked in the
upright posi ...
Important notes on use
To function properly, BlueTEC exhaust gas
aftertreatment must be operated with the
reducing agent DEF.
When the DEF supply has almost run out, the
Check Additive See Operator's
Manual message ...
General notes
USA only:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference, and
2. this device mus ...