Setting the map scale

the COMAND To hide the menu: slide the COMAND the COMAND controller and, when the Full screen menu item is shown, press To call up the scale bar: as soon as you.

turn To call up the scale bar: as soon as you turn the COMAND controller, scale the COMAND controller, scale bar 3 appears.

until the desired scale is set. Turn until the desired scale is set. until the desired scale is set.

1 Set map scale as a number with unit

1 Set map scale as a number with unit
2 Currently set map scale as indicated by the needle on the scale bar
3 Scale bar

Unit of measurement 1 in the COMAND display depends on the selection made for the instrument cluster.

    See also:

    Deactivating/activating ESP®
    Observe the "Important safety notes" section. WARNING   ESP® should not be deactivated during normal driving other than in the circumstances described below. Disabling the s ...

    Heavy and light loads
    WARNING Depressing the brake pedal constantly results in excessive and premature wear to the brake pads. It may also cause the brakes to overheat, seriously impairing their effectiveness. I ...

    Other bulbs
    There are bulbs other than the Xenon bulbs that you cannot replace. Replace only the bulbs listed. Have the bulbs that you cannot replace yourself changed at a qualified specialist workshop. ...