Storing the crosshair position in the list of previous destinations

Route guidance not active

A crosshair appears on the map if you have moved the map manually. You can store the crosshair position as a destination in the list of previous destinations.

the COMAND To show the menu: press the COMAND the COMAND controller.

menu bar by turning Select Position in the navigation system menu bar by turning the COMAND the COMAND controller and press Select Save Crosshair Position and to confirm.

press  to confirm. Select Save Crosshair Position and press Route guidance is active to confirm.

Route guidance is active

system menu bar by turning Select Destination in the navigation system menu bar by turning the the COMAND controller and press confirm. to confirm.

to Select Save Destination and press to to confirm.

    See also:

    Service messages
    Information on the type of service and service intervals (see separate Service Booklet). You can obtain further information from an authorized Mercedes-Benz Center or at http://www.mbusa.com (US ...

    introduction
    You can establish a Bluetooth® connection to COMAND (see the separate operating instructions). WARNING A driver's attention to the road must always be his/her primary focus when driving. F ...

    Notes for 4MATIC vehicles
    Vehicles with 4MATIC must not be towed with either the front or the rear axle raised, as doing so will damage the transmission. If the vehicle has transmission damage or damage to the fron ...