Home address (My address)
Entering the home address via address entry
Enter the home address as a destination,
e.g. as a city, street and house number. Then, save the home address
without starting route guidance.
Adopting an address book entry as a home address
To activate navigation mode: press the
S function button once or twice.
To show the menu: press
the COMAND
controller.
Select Destination in the navigation
system menu bar by turning
the
COMAND controller and press
to
confirm.
Select From Memory and press
to
confirm.
Slide
the COMAND controller
repeatedly until the destination memory
list appears as a selection list.
Select My Address by turning
the
COMAND controller and press
to
confirm.
If you have not yet entered any
characters, the My Address entry is
automatically highlighted in the selection
list.
If no home address has been stored yet, you can now assign an address book entry. If a home address already exists, it is displayed and you can alter it.
If you select New Entry, you are also
offered the option of entering the home
address for the first time. You can then
save the home address without starting
route guidance.
To enter the home address for the first
time: select Assign Address Book
Entry and press
to confirm.
Select Home or Work and press
to
confirm.
To change the home address: select
Change and press
to confirm.
Select Assign Address Book Entry and
press
to confirm.
If you select New Entry, you are also
offered the option of changing the home
address by entering an address. You can
then save the home address without
starting route guidance.
Select Home or Work and press
to
confirm.
In both cases, you will see the address book either with the character bar or as a selection list.
To select an address book entry: proceed as described in the
"Searching for
an address book entry" section.
To confirm the selection: press
the
COMAND controller.
If no home address has been stored, COMAND saves the entry. You will see a message and then the address menu with the selected address. Start is highlighted automatically.
If a home address has already been stored, you will see a prompt asking you whether the My Address entry should be overwritten.
Select Yes or No and press
to
confirm.
If you select Yes, COMAND overwrites the destination. You will see a message and then the address menu with the selected address. Start is highlighted automatically.
If you select No, the list will reappear.
Selecting the home address for route guidance
Proceed as described in the "Selecting a
destination from the destination memory"
section.
See also:
Changing gear
The automatic transmission shifts to the
individual gears automatically when it is in
transmission position D. This automatic
gearshifting behavior is determined by:
• a shift range restricti ...
Important safety notes
The fuses in your vehicle serve to close down
faulty circuits. If a fuse blows, all the
components on the circuit and their functions
stop operating.
WARNING
Only use fuses approved by Merce ...
Driving on sand
WARNING
Do not reduce the tire inflation pressure
before driving through sand. However, if you
do so, remember to correct the tire inflation
pressure before continuing your trip. Drivi ...