Displaying destination information

Prerequisite: you have entered a destination and possibly an intermediate stop.

To activate navigation mode: press the function button once or twice. function button once or twice.

the COMAND To show the menu: press the COMAND the COMAND controller.

Select Info in the menu bar by turning the COMAND controller and press the COMAND controller and press Destination information is displayed. to confirm.

Destination information is displayed.

If a telephone number is entered for the address displayed, you can also select and call the number using COMAND.

telephone number using the COMAND To call the destination: select the telephone number using the COMAND controller and press To close the destination information: slide to confirm.

the COMAND controller or press To close the destination information: slide the  back button. the COMAND controller or press the Route overview back button.

    See also:

    Radiator
    Vehicles with a diesel engine: do not cover the radiator, for example with a winter front or bug cover. The readings of the on-board-diagnostic system may otherwise be inaccurate. Some of ...

    Monitoring range of the sensors
    Blind Spot Assist monitors the area shown in the figure up to 10 ft (3 m) behind and immediately adjacent to your vehicle. WARNING   Blind Spot Assist monitors certain areas in the im ...

    GVWR (Gross Vehicle Weight Rating)
    The GVWR is the maximum permissible gross weight of a fully loaded vehicle (the weight of the vehicle including all accessories, occupants, fuel, luggage and the drawbar noseweight, if applica ...