Entering a destination using the map
Calling up the map
To activate navigation mode: press the
function button once or twice.
To show the menu: press
the COMAND
controller.
Select Destination in the navigation
system menu bar by turning
the
COMAND controller and pressing
to
confirm.
Select Via Map and press
to confirm.
You see the map with the crosshair.
1 Current vehicle position
2 Crosshair
3 Details of the crosshair position
4 Map scale selected
Display 3 depends on the settings selected in "Map information in the display". The current street name can be shown, provided the digital map contains the necessary data, or the coordinates of the crosshair if the geo-coordinate display is switched on and the GPS signal is strong enough.
Moving the map and selecting the destination
To scroll the map: slide
,
or
the COMAND controller.
To set the map scale: as soon as you turn
the COMAND controller, the scale
bar
appears.
Turn
until the desired scale is
set.
Turning clockwise zooms out from the map; turning counter-clockwise zooms in.
To select a destination: press
the
COMAND controller once or several times.
You will see either the address entry menu with the destination address or, if COMAND is unable to assign a unique address, a selection list.
Select a destination by turning
the
COMAND controller and press
to
confirm.
If the destination is within the limits of the digital map, COMAND attempts to assign the destination to the map.
If the destination can be assigned, you will see the address entry menu with the address of the destination. If not, you will see the entry Destination from Map.
To start route calculation: select Start
and press
to confirm.
See also:
Useful information
This Operator's Manual describes all
models and all standard and optional
equipment of your vehicle available at the
time of publication of the Operator's
Manual. Country-specific differences are ...
Servicing the brakes
If the red brake warning lamp lights up in
the instrument cluster and you hear a
warning tone while the engine is running,
the brake fluid level may be too low.
Observe additional warning me ...
Range of the sensors
General notes
The sensors must be free of dirt, ice and slush; otherwise they may not function
correctly. Clean the sensors regularly, taking care not to scratch or damage them
().
Side view
...