External authorization
If COMAND does not detect your Bluetooth® device, this may be due to particular security settings on your Bluetooth® device. In this case, you can test if your Bluetooth® device can find COMAND.
The Bluetooth® device name of COMAND is "MB Bluetooth".
Select Update.
Select Options by sliding
the
COMAND controller and press to
confirm.
Select External Authorization and
press to confirm.
Start the Bluetooth® scan process on the
Bluetooth® device (see separate operating
instructions of the respective device).
Select COMAND ("MB Bluetooth").
The order in which the passkey is entered depends on the mobile phone.
Enter the passkey on the Bluetooth® device
when prompted.
Confirm the Do you want to authorize
XX? question in COMAND with Yes.
Enter the passkey in COMAND.
See also:
Setting the rear-compartment air
distribution using the rear control panel
Turn the SmartKey to position 2 in the
ignition lock.
Press rocker switch 13 or 16 up or down
repeatedly until the desired
air distribution symbol is shown in the
display. ...
Low-beam headlamps
► To switch on the low-beam headlamps:
turn the SmartKey in the ignition lock to
position 2 or start the engine.
► Turn the light switch to
.
The indicator lamp in the
instru ...
Making adjustments in 5 mph (Canada: 10 km/h) increments
Briefly press the cruise control lever beyond the pressure point, up 1 for a
higher speed or down 2 for a lower speed. The last speed stored is increased or
reduced. ...