Text reader settings

Setting the text reader speed

the Select Vehicle by turning COMAND controller and press to the COMAND controller and press confirm. to confirm.
confirm. Select System and press confirm. to confirm.
to Select Text Reader and press confirm. to confirm.
to confirm. Select Set text reader speed and press to confirm.
A list appears. The the dot indicates the current setting.
COMAND controller and press to Select a setting by turning COMAND controller and press to the COMAND controller and press confirm. to confirm.

    See also:

    Preparing the vehicle
    Your vehicle may be equipped with a "Minispare" emergency spare wheel or MOExtended tires (tires with run-flat properties). Vehicle preparation is not necessary on vehicles with MOEx ...

    Checking the coolant level
    Only check the coolant level when the vehicle is on a level surface and the engine has cooled down. Turn the SmartKey to position 2 in the ignition lock. On vehicles with KEYLESS-GO, press th ...

    Towing the vehicle with the rear axle raised
    Only possible on vehicles without 4MATIC. When towing your vehicle with the rear axle raised, it is important that you observe the safety instructions. The ignition must be switched off if ...