Display design

Your COMAND display features optimized designs for operation during daytime and night-time hours. You can customize the design to suit your personal preferences by manually selecting day or night design or opt for an automatic setting.

the Select Vehicle by turning COMAND controller and press  to the COMAND controller and press confirm. to confirm.
the Select System by turning the the COMAND controller and press confirm. to confirm.
to confirm. Select Display and press to confirm. to confirm.
Automatic by turning  the Select Day Mode, Night Mode or Automatic by turning COMAND the COMAND controller and press to confirm.
The setting. icon indicates the current setting.

In the Automatic setting, COMAND

evaluates the readings from the automatic In the Automatic setting, COMAND evaluates the readings from the automatic vehicle light sensor and switches between the display designs automatically.

    See also:

    Setting the temperature in the rear compartment using the rear control panel
    Turn the SmartKey to position 2 in the ignition lock. To increase/reduce: press rocker switch 12 or 17 up or down. Only change the temperature setting in small increments. Start at 72 °F (22 ...

    Adjusting the four-way lumbarsupport
    You can adjust the contour of the driver's seat backrests individually to provide optimum support for your back. 1 To raise the backrest contour 2 To soften the backrest contour 3 To lower the ...

    Important safety notes
    Do not leave the SmartKey in the trunk/cargo compartment. You could otherwise lock yourself out. WARNING When leaving the vehicle, always remove the SmartKey from the ignition lock. Always ...