Remote control
Overview
1 To switch the screen on/off
2 To switch the button lighting on/off
3 To select the screen for remote control operation (COMAND, SPLITVIEW, L REAR
and REAR R can be selected)
4 To select a menu or menu item
5 To confirm a selection or setting
6 To switch sound on/off (for corded headphones)
7 To adjust the volume (for corded headphones)
8 To skip; fast-forward/fast-rewind
9 To select a track; direct entry
10 To exit a menu (back)
Selecting the screen for the remote control
You can use the remote control to operate one of the two rear screens at a time. To do so, you must switch the remote control to the desired screen.
To select the left-hand screen: turn
thumbwheel 3 until "L REAR" is
highlighted in the window.
To select the right-hand screen: turn
thumbwheel 3 until "REAR R" is
highlighted in the window.
Switching the screen on/off
If the SmartKey in the ignition lock is in position 0 or 1 or if the SmartKey is not in the ignition lock, the rear screens will switch off after 30 minutes. Before the screens switch off, they show a message to this effect.
You can switch the screens back on.
However, this will discharge the starter battery.
Point the remote control at the rearcompartment
screen which has been
selected for remote operation.
Press button 1 on the remote control.
The respective rear screen switches on or
off.
You can only switch the screens on using
the remote control if the ignition is
switched on.
Switching the button lighting on/off
Press button 2 on the remote control.
Depending on the previous status, the
button lighting is switched on or off.
If you do not use the remote control for
about 15 seconds, the button lighting
switches off automatically.
Switching the sound on/off (corded headphones only)
Press button 6 on the remote control.
The sound is switched on/off.
Selecting a menu/menu item and confirming your selection
Press the
buttons to
select the menu/menu item and press the
button to confirm.
See also:
Setting the temperature in the rear
compartment using the rear control
panel
Turn the SmartKey to position 2 in the
ignition lock.
To increase/reduce: press rocker
switch 12 or 17 up or down.
Only change the temperature setting in
small increments. Start at 72 °F (22 ...
Search & Send
Points to observe before use
To use Search & Send, your vehicle must
be equipped with mbrace and a navigation
system. You must also have an mbrace
service subscription.
"Search & ...
Displaying the current fuelconsumption
► Press
on the steering wheel
to select the trip computer menu.
► Press
to select
Consumption.
The current fuel consumption is displayed.
...