Preparing the vehicle

Your vehicle may be equipped with:

 - TIREFIT kit
 - a "Minispare" emergency spare wheel
 - a collapsible spare wheel
 - MOExtended tires (tires with run-flat properties)

Vehicle preparation is not necessary on vehicles with MOExtended tires.

Vehicles equipped with MOExtended tires are not equipped with a TIREFIT kit at the factory. It is therefore recommended that you additionally equip your vehicle with a TIREFIT kit if you mount tires that do not feature run-flat properties, e.g. winter tires.

A TIREFIT kit can be obtained from an authorized Mercedes-Benz Center.

•► Vehicles with AIRMATIC: make sure that "normal" level is selected

Stop the vehicle as far away as possible from traffic on solid, non-slippery and level ground.

•► Switch on the hazard warning lamps.

•► Firmly depress the parking brake.

•► Bring the front wheels into the straightahead position.

•► Move the selector lever/DIRECT SELECT lever to P.

•► Switch off the engine.

•► Vehicles without KEYLESS-GO: remove the SmartKey from the ignition lock.

•► Vehicles with KEYLESS-GO: open the driver's door.

The on-board electronics have status 0, which is the same as the SmartKey having been removed.

•► Vehicles with KEYLESS-GO: remove the Start/Stop button from the ignition lock

•► All occupants must get out of the vehicle.

Make sure that they are not endangered as they do so.

•► Make sure that no one is near the danger area while a wheel is being changed.

Anyone who is not directly assisting in the wheel change should, for example, stand behind the barrier.

•► Get out of the vehicle. Pay attention to traffic conditions when doing so.

•► Close the driver's door.

    See also:

    Route mode
    Setting route type and route options You can select the following route types: • Fast Route: COMAND calculates the route with the shortest (minimized) journey time. • Dynamic Route: same ro ...

    Adjusting the seats
    Vehicles without Memory function: the seats can be adjusted within three minutes of a front door being opened. The time period starts over again if, within these three minutes, you: • open or ...

    TIREFIT kit version 1
    ► Open flap 2. ► Pull connector 5 with the cable and hose 6 out of the housing. ► Screw hose 6 onto flange 7 of tire sealant bottle 1. ► Insert tire sealant bottle : hea ...